How to use the king and queen in clash of clans
I placed the king and queen tiles (i.e. the heroes) near the center of the village surrounded by at least two fortification walls, each wall separated by buildings, like this.
When the village is under attack and one attacker's soldier enter the hero's range of attack, the hero moves in direction to the attacker but stops when the attacker dies, even when there are more attackers in range.
It seems as if there is pause after the hero detects the attacker but before he/she stars moving in that direction, so the end result is that the heroes just freeze, until there are no more attackers in their range.
Something like:
Oh... there is an attacker out there.
...but I'm going to wait a little.
Ok, I'm coming.
Hey, what happened, the attacker just died.
And that sequence repeats again and again, with each attacker in their range.
Best Answer
Its just what it is man, I know it sucks. The AI isn't very good for the Kings and Queens. I advise upgrading your other defenses and getting them higher level than trying to work with broken AI
Pictures about "How to use the king and queen in clash of clans"
How do you use the Archer Queen in clash of clans?
Queen Walk is not hard to be explained, but it takes a while to make it right: you release her with Healers behind and be careful to keep them alive, the Healers and the Queen. To direct her to the important buildings, use Wall Breakers or Jump Spell. To boost the healing rate, use Rage Spell on them.How do you do the Queen walk in clash of clans?
Unless there is some important change(like one-shotting builder huts) one more ability level is better to the king than to the queen. If the queen is not one under max, then upgrade her.How to BEST USE your ARCHER QUEEN in Clash of Clans!
Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.
Images: Pixabay, Pixabay, sk, George Becker