Minecraft: Is there a way to activate command blocks even if you're not within range? [duplicate]

I'm trying to create a unique skywars in vanilla minecraft by using command blocks, but the (clone) command I'm using to reset the map will only activate when someone is within range. For example if I use the command (setblock x y z redstone_block) to run the clone command, I have to be within a certain distance for the clone to actually do its intended job. For a normal map, "spawn chunks" would work, but I have made my skywars in the end so the players would immediately fall to their deaths.

Is there a way to activate the command after the game is finished and no one is still near the command blocks?

minecraft-java-edition minecraft-commands

Pictures about "Minecraft: Is there a way to activate command blocks even if you're not within range? [duplicate]"

Minecraft: Is there a way to activate command blocks even if you're not within range? [duplicate] - Back view of anonymous young female in casual clothes riding horse on rural road during sundown in countryside

Minecraft: Is there a way to activate command blocks even if you're not within range? [duplicate] - Horse rider on road in countryside at sunset

Minecraft: Is there a way to activate command blocks even if you're not within range? [duplicate] - Unrecognizable people riding bicycle against sunset

How do you get command blocks always active?

A command block can also be activated by setting it to "Always Active" mode. When activated, a command block executes its command, depending on the command block's type: An impulse command block executes its command once.

Do Minecraft command blocks have a range?

Range 2 is the range a player want for a command block under a floor. Keep in mind that it will produce a globe shaped trigger area (rather than a cube), so a range of 2 makes an approximately 5\xd75\xd75 area and a range of 1 makes a 3\xd73\xd73 area (more like a + pattern with an extra block above and below the center).

How do I enable command blocks without restarting?

Enable Command Blocks

Head to your multicraft control panel and select the Config Files tab on the left hand side.

Select Server Settings which will be at the top of the page.

Scroll down the page until you find Enable Command Blocks.

Set this setting to Enabled and then click save.

How do you activate multiple command blocks?

To make your command block run multiple commands, you will need to summon FallingSand or falling_block (depending on your version of Minecraft) with command blocks and redstone blocks for each command. The command blocks will be stacked one on top of the other and contain the individual command.

Tip: How to Use Command Blocks in Minecraft

Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.

Images: Dziana Hasanbekava, Helena Lopes, Helena Lopes, mamunurpics