Minecraft - Redstone Sequence for Minecart Trap?
I'm trying to create a simple catcher for a railway. I have the following set-up going on but there's a slight problem when you turn it off... It breaks since there's a gap. Is there a better way or someway I can switch up the delay between the two pistons? Btw, I do want to have it on 1 lever.
Best Answer
This is a very simple mechanic. You just need the mechanic above, but without the repeaters.
The piston that is pushing and pulling the red wool is sticky.
When activated, whala!
Pictures about "Minecraft - Redstone Sequence for Minecart Trap?"
How do you make a piston trap in Minecraft?
Place the powered rails inside the trench, connect one end to the track that you wish the minecart to exit. Finally, place the minecart on the powered rail. Once power is applied to the rail, the minecart is boosted out.How to push minecart?
Pistons can push most blocks, and sticky pistons can pull most blocks, except those listed in the table below. A sticky piston simply leaves a block behind if it cannot pull it. Pistons cannot push blocks into the void or beyond the top of the map. They also cannot push more than 12 blocks.5 super simple TNT minecart based traps to troll your friends
Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.
Images: Pixabay, RODNAE Productions, RODNAE Productions, Yan Krukov