Xbox One Afterglow remote
So my XBOX ONE Afterglow controller will still power on, but it won't respond to controls. It won't turn on my system from the remote by holding down the "X". The Afterglow app on my system says the remote isn't connected, when it firmly is. I've tried powering off/on, & leaving it disconnected. The cable appears not to have any short, as it's able to charge my daughters' Leap Pad. Any suggestions?
Best Answer
Try resetting the remote as outlined in this answer on a different question:
Afterglow Prismatic Controller Xbox One Reset?
Power the XBOX one console on.
Plug the smaller end of the controllers USB-B micro cable into the top of the controller.
Hold down on the directional pad (D-Pad) and plug the larger side of the USB cable into the XBOX one console while still holding down.
The controllers red LED lights will illuminate and the controller will begin to vibrate. You may then release the down input on the directional pad (D-Pad)
Press A on the controller.
The controller will then stop vibrating and the LED lights will power off.
Fully rotate both joysticks in a complete clockwise motion and pull each trigger fully (LT and RT)
Press down on the directional pad (D-Pad)
Pictures about "Xbox One Afterglow remote"
Do Afterglow controllers work on Xbox One?
The Afterglow Wired Controller works on Xbox Series X|S, Xbox One, and Windows 10 and is an officially licensed product.Is Afterglow a good controller?
5.0 out of 5 stars Very good! Overall, an excellent controller. The build quality is excellent; this controller feels very sturdy to hold, and the buttons have a tactile, responsive feel.What does the Afterglow controller do?
Enhance your gaming experience with the Afterglow Prismatic wired Controller, Officially Licensed by Microsoft for Xbox One. With new dimmable Prismatic LED lighting available through full color range LEDs, gamers can set their favorite color, cycle through the Rainbow, or turn off the lights completely.How do I program my Afterglow controller?
Press the program button on the back of the controller three times. The program status LED will turn yellow. Press the D-Pad UP to set the rumble / impulse LEDs to ON, or press the D-Pad DOWN to set the LEDs to OFF. Minimal maintenance is required.Xbox Afterglow wired controller Color Select Lighting prismatic Unboxing
Sources: Stack Exchange - This article follows the attribution requirements of Stack Exchange and is licensed under CC BY-SA 3.0.
Images: thiago japyassu, Anton Porsche, Bruno Henrique, Corentin Detry